Talk:NORD-10 Serial 619

A PC power supply must be severely under-dimensioned I think? The ND power supplies I've seen have been 200A or 300A at +5V.. -- TArntsen (talk) 11:25, 1 May 2019 (UTC)

Card in slot 18 should be Panel Transceiver, PCB 1114. I do suspect an ATX power supply would be ok for one or two racks only if its the older ATX with 5V primary power.

Anyway, I think the panel transceiver might be a necessity if we are to get it running again. You need to check cards laying about, and I will prioritize getting one drawn upp in KiCAD just in case.. Roger (talk) 18:20, 1 May 2019 (UTC)

Also card in slot 13 is most likely wrong, according to manuals the cache card, 1126, should be located in this slot.

Backwiring on these slots should tell if my assumtions are correct however. -- Roger (talk) 19:07, 1 May 2019 (UTC)

Regarding HAWK disk, card 1022 and 1122 is totally different, 1122 is 4x current loop terminal interface. Roger (talk) 13:03, 7 May 2019 (UTC)