User talk:Gandalf/hw/filestore 2

tape drive - what kind of tapes?

The tape drive is interesting. Is 1/2 inch (I'm guessing that means that the tape itself is 0.5 inch wide) tape the same as "9-track tape"? And, is this the same as CCT (Computer Compatible Tape)? In A recent haul, I got some 0.5 inch wide tapes, but I don't have a tape drive. --Torfinn (talk) 11:28, 25 June 2016 (UTC)

The half-inch tapes are CCTs, and, in this case, 9-track CCT. But there was also 7-track CCTs, an earlier standard. Your tapes are probably 9-track. No markings at all? If you see 6250bpi or 1600bpi anywhere, it's 9-track. If you see 800bpi it's almost certainly 9-track too, although that density was shared with a tiny selection of 7-track drives for a short time window, afaik. ND used only 9-track CCT drives. The drive in the picture looks quite similar to some drives we used at work, although I don't recall them to be StorageTek. But we also had the CDC small division SCSI disks at the same time (630MB formatted), so it's possible. Those drives had problems with CCTs from long storage, if they had become sticky. I would run the tape once through an Anritsu DMT 2820 drive first, then read the tape successfully in the ND drive (I own that Anritsu now, I used it later to read my old ND (and a few VAX) tapes, after the last ND computer was gone. Had to write some software first, of course). --TArntsen (talk) 21:41, 25 June 2016 (UTC)

Yes, it's a 9-track tape. (Had to read up on the subject first. :-) ) I'm suspecting that it is a later model than the 1950. It is a StorageTek at least but the card crate has fewer cards than the service manual for the 1950 shows.

Since it is a SCSI unit it should be quite easy to connect a linux computer and test the drive. If it is working I should be able to image any tapes.

So far I've only tested to run the drive manually without any tape, just powered it on and played with the operators panel. It seems to be working so far, tries to load tape, rewinds, operator panel works.

Just found a quick guide on sintran.com. The drive was called ND-110324 Magtape by ND. I still would like to know the storagetek model number to be able to find a service manual. --Gandalf (talk) 22:47, 25 June 2016 (UTC)

Found a label inside the drive, it's a StorageTek 2920, but I haven't found any manuals for it. --Gandalf (talk) 23:24, 25 June 2016 (UTC)