150 (NORD-1 card): Difference between revisions
Jump to navigation
Jump to search
(→BOM) |
(Added some more info) |
||
| Line 1: | Line 1: | ||
'''150 Register''', is a card that is used in the [[NORD-1]] CPU. | '''150 Register''', is a card that is used as the instruction register in the [[NORD-1]] CPU. It holds the current instruction during execution. | ||
[[Image:NORD-1 card 150-c.jpg |300px | thumb | Component side.]] | [[Image:NORD-1 card 150-c.jpg |300px | thumb | Component side.]] | ||
[[Image:NORD-1 card 150-s.jpg |300px | thumb | Solder side.]] | [[Image:NORD-1 card 150-s.jpg |300px | thumb | Solder side.]] | ||
| Line 16: | Line 16: | ||
The logic diagram is documented in drawing '''2A50'''.<ref>HARDWARE MANUAL NORD 1</ref> | The logic diagram is documented in drawing '''2A50'''.<ref>HARDWARE MANUAL NORD 1</ref> | ||
The content of the IR is set by the MJ-bus and strobed by the IS1-0 signal on pin 29 and 30. | |||
The IS2-0 strobe forces the IR to 161402 (IOT SKA #2) or 161422 (IOT SKA #22) depending on the state of LEN-1, this is a load sequence initiated from the [[NORD-1 Operators panel|operators panel]]. | |||
IS2-0 strobe comes from the [[122 (NORD-1 card)|122 Assembler]] card, where the IS1-0 signal comes from isn't known yet. | |||
==Switches and indicators== | ==Switches and indicators== | ||
There are no switches or indicators on this board. | There are no switches or indicators on this board. | ||
Latest revision as of 11:26, 25 July 2016
150 Register, is a card that is used as the instruction register in the NORD-1 CPU. It holds the current instruction during execution.
 |
This article is a stub. You can improve NDWiki by expanding it. |
Introduction
The card is made in the standard NORD-1 card format.
| CPU model | Crate position |
|---|---|
| 29 | C09 |
| 35 | C09 |
The logic diagram is documented in drawing 2A50.[1]
The content of the IR is set by the MJ-bus and strobed by the IS1-0 signal on pin 29 and 30. The IS2-0 strobe forces the IR to 161402 (IOT SKA #2) or 161422 (IOT SKA #22) depending on the state of LEN-1, this is a load sequence initiated from the operators panel.
IS2-0 strobe comes from the 122 Assembler card, where the IS1-0 signal comes from isn't known yet.
Switches and indicators
There are no switches or indicators on this board.
BOM
This list contains the logic circuits used, passive components are not listed.
- 4 x 7400
- 4 x 7440
- 8 x 7474
Reference
- ↑ HARDWARE MANUAL NORD 1
- Hardware in NORD-1 Serial 47